Wednesday, February 20, 2013

'robinson house studio' London Trip 20/02/2013

V&A Museum


In December last year the V&A Museum opened their new furniture gallery featuring works by Thomas Chippendale, Charles and Ray Eames, Frank Lloyd Wright, Ron Arad, Jasper Morrison, Eileen Gray and Michael Thonet, to name but a few. The exhibition tells the story of furniture through the ages, exploring the progression of design as well as the development of techniques in construction.


The display down the centre of the room focused on the furniture timeline whilst around sides of the room the pieces were grouped according to the techniques used, ie. veneering and marquetry, upholstery etc. Dotted here and there are also displays dedicated to prolific designers like Frank Lloyd Wright and Michael Thonet.


Page Lacquer

After a spot of pizza for lunch we made our way over to Page Lacquer who specialise in polyester lacqer finishing. We were shown around by Juliet Page, one of the directors, who explained the processes involved in lacquering. They have a huge range available - approximately five thousand different finishes, and even make some of the furniture they spray. 


My favourite part of what they do is the emphasis on experimentation. Everyone in the workshop is encouraged to use any free time they have to experiment with new ideas, colours and textures, and if a client has an idea that is different to any of their pre-existing finishes, they will strive to come up with something that fits the bill.


Marc Fish Latest Piece

The as yet untitled cabinet we are making is back in full swing. I spent last week applying 3 or 4 coats of polyester primer which needed to be sanded back in between coats and any remaining small holes filled.

          

Chris then sanded the whole former to 1500 grit before polishing. Polishing the former enables the fiberglass doors to come away from it after the glue has set.



We marked out the datum lines using masking tape as a pen or pencil won't show up on black gloss.


After that, the former was finished and we could begin fiberglassing the doors.


Once the epoxy resin goes off, the door can then be cut into the desired shape!


In the next few days we will be laying up the second door and after that we can begin laying veneers over the fiberglass in the same fashion as Mollusque.

Inspiration of the week

Each week we will be adding a new inspirational section to the blog. We will post photos, furniture, buildings, art, anything that catches our eye and inspires us.

To kick it off I'd like to share my personal favourite, and also one of Marc's favourites from the V&A trip - The Fractal Table made in resin using 3D printing technology. The link below the photo is to a video of how it was made so do check it out!




More to come next week

Danny

No comments: